another probe attempt

Marlin/Configuration.h

 #define USE_ZMIN_PLUG
 //#define USE_XMAX_PLUG
 //#define USE_YMAX_PLUG
-#define USE_ZMAX_PLUG
+//#define USE_ZMAX_PLUG
 
 // Enable pullup for all endstops to prevent a floating state
 #define ENDSTOPPULLUPS
  *     |    [-]    |
  *     O-- FRONT --+
  */
-#define NOZZLE_TO_PROBE_OFFSET { -37, 2, -3.04 }
+//define NOZZLE_TO_PROBE_OFFSET { -37, 2, -3.04 }
+#define NOZZLE_TO_PROBE_OFFSET { -37, 2, -3 }
 
 // Most probes should stay away from the edges of the bed, but
 // with NOZZLE_AS_PROBE this can be negative for a wider probing area.
  * Normally G28 leaves leveling disabled on completion. Enable
  * this option to have G28 restore the prior leveling state.
  */
-#define RESTORE_LEVELING_AFTER_G28
+//#define RESTORE_LEVELING_AFTER_G28
 
 /**
  * Enable detailed logging of G28, G29, M48, etc.
   // Gradually reduce leveling correction until a set height is reached,
   // at which point movement will be level to the machine's XY plane.
   // The height can be set with M420 Z<height>
-  #define ENABLE_LEVELING_FADE_HEIGHT
+  //#define ENABLE_LEVELING_FADE_HEIGHT
 
   // For Cartesian machines, instead of dividing moves on mesh boundaries,
   // split up moves into short segments like a Delta. This follows the
 // - Move the Z probe (or nozzle) to a defined XY point before Z Homing.
 // - Prevent Z homing when the Z probe is outside bed area.
 //
-#define Z_SAFE_HOMING
+//#define Z_SAFE_HOMING
 
 #if ENABLED(Z_SAFE_HOMING)
   #define Z_SAFE_HOMING_X_POINT X_CENTER  // X point for Z homing