Tested with M43 and found to be connected to DIO 2

Everywhere in menu items temperatures are "defined value" subtracted by 15.
In one place is subtracted by 5

* Work around for serial buffer over run

PronterFace sends a lot of M105 commands.  During long operations such
as UBL's G29 P1, G29 P2, G29 P4 and G26 this can over run the serial
buffer.   This results (very often) in a M1 (actually a M1M105) ending
up in the command queue.

Until we figure out a better way to resolve this issue, this will keep
the UBL commands from experiencing bogus commands at thier completion.

Pin 6 is only used by servos when 2 or more of them are used

Give PronterFace time to print the UBL What information...

A number of regressions were patched also. The UBL G29 P2 and P4 Press and Hold had stopped working. It is very possible this is broken in the bugfix_v1.1.x branch also.

The main purpose of the Pull Request is to get the 3-Point mesh tilting to use the LSF algorithm just like the grid based mesh tilt. This simplifies the logic and reduces the code size some what. But the real reason to do it is the 3-Point case can be solved exactly. And by feeding these numbers into the LSF algorithm it provides a way to check all that code for 'correctness'.

Misc formatting

Fix #9155

Followup to #8148

Some also get a `HAL_timer_interrupt_enabled` function.

This will save some program memory with no speed lose

It seems that some SD cards don't support CRC_ON_OFF command. This fix will permit to use also these cards but leaving CRC check active on the system