- Original CR-10
- MKS Mini Display

As pointed out in #7692 by @totalitarian

Forgot to update examples configurations. Done now

Ideally, it should be calculated based on Z steps per unit so that each
babystep corresponds to around 0.025mm. Smaller than this is largely
insignificant for typical layer heights.

* Add MAX7219_DEBUG to Travis CI testing

* Tweak config and use standard pin naming for MAX7219_DEBUG

* MAX7219: Apply coding standards, use macros, etc.

* Make code work...

* Add Max7219 LED Matrix Debug Support

The Max7219 8x8 LED Matrix's are very helpful for debugging new code.
And for that matter, just trying to maximize printer settings without
causing stuttering.

The displays are very inexpensive (under $2.00 with shipping) and
provide a lot of help when trying to debug complicated code.

* Try to keep Makefile up to date.

Slovak UTF-8 translation

This modify give SERVO_DELAY x servo basis

Add a parameter to enable/disable audible user script feedback

Connected as described at http://printrbot.com/shop/led-strip/

Based on patch by Kelly Anderson <kelly@xilka.com> at
http://www.xilka.com/printrbot/marlin/1.1.4/20170707/

Add more details as requested in #7198

Creality board is a Melzi / Sanguinololu variant, but using different pins for LCD control (and maybe other minor variations)

Sends pre-defined string as action command when printer is kill.

Probing with the effector in the printing area, but an eccentric probe (e.g. allen key) outside it but still touching the bed gives meaninfull information for calibration. Since calibration is most accurate when probing as close to the towers as possible the testing was way to restrictive hence this fix.

Based on Infitary's own firmware settings.