Since a removal or insert of the sd card takes a long time in firmware, just reinitializing the lcd does not hurt.
actually, it solves a problem with the UltiControlle

M303 Starts autotune. Wait till the Kp Ki and Kd constants are printed.
Put these values in Configuration.h

The percent complete now lines up with the temperatures and Z-axis position figures, nicer to read and nicer to look at IMHO.

Instead of adding a momentary switch to fake the insertion of the card I have modified the ultralcd menu item:

Card Menu -> Refresh

to reinitialise the card providing that the SDCARDDETECT pin has been set to -1 in the pins.h file.  This requires one less switch on the front panel and the refresh menu item is in the most relevent place for a user who wishes to inert a card and then print from it.

It also means that the "Card inserted" messages do not bother the users of these card readers (they dont make sense for users without SCCARDDETECT)

Split ramps1.3 in Sprinter like config and multiextruder config.

I find that the PID routine works better when the cooling fan is switched on
at the beginning of a warm up routine.  Otherwise when you enable the fan
just before a print, you have a delay as the PIDre-adjusts.

This should also be safer as most cooling fans are directed at the hot -ends
thermal barrier!

Instead of a single pre-heat, now there is pre-heat ABS and PLA options
Added defines to the configuration file to adjust preheat temperatures for both

Updated the Xsteps ... settings via the LCD menu

Signed-off-by: Blair Thompson <mail@justblair.co.uk>

- redo disable Beeper if PIN is set to -1

Added late z enable. (blddk request)
Only calculate look ahead if >2 moves in buffer.
Removed some FORCE_INLINE to save memory.

Signed-off-by: Erik van der Zalm <erik@vdzalm.eu>

advance and ultipanel not any more in default config

Soft PWM. (Sanguinololu can also have PID temperature control)
Interrupt save WRITE for addresses > 0x0FF

Found a couple of unused variables, that I commented.
Tried to solve the program memory warning message, and failed.

Merge branch 'Marlin_v1' of https://github.com/ErikZalm/Marlin into Marlin_v1

Conflicts:
	Marlin/Marlin.pde
	Marlin/ultralcd.h