2.0.x FAST_PWM_FAN updates & make LPC1768 PWM use fewer CPU cycles

include LPC1768 syntax for M42

couple more pin_t changes

consistency

change M42 to R, P format

Revert "change M42 to R, P format"

This reverts commit 01f12f579e.

[2.0] No retroactive adjustment with M851 Z

[2.0.x] Apply some formatting

If using babystep to adjust the Z probe offset, the axis will move and the mesh will be updated at the same time, causing a doubling of the Z offset over the rest of the print.

To correct for this, the current Z position would need to be modified in the opposite direction, canceling out the additional Z offset added to the mesh. This would be confusing to users, and moreover it would not be accurate without also taking the current Z fade level and current Z height into account.

It might make sense to change the mesh in the case where no babystepping is taking place, but this could be considered an undesirable side-effect of changing the `zprobe_zoffset`.

One way to remedy this would be to return to storing the mesh with `zprobe_zoffset` included, then subtracting `zprobe_zoffset` from the returned Z value. Thus, a babystep moving the Z axis up 1mm would subtract 1 from `zprobe_zoffset` while adding 1 to all mesh Z values.

Without including the `zprobe_zoffset` in the `z_values` there is no safe way to alter the mesh in conjunction with babystepping, although it's fine without it.

This is a non-intuitive change.   @oldmcg says in this post https://github.com/MarlinFirmware/Marlin/issues/7572#issuecomment-340641207 that using DELTA_PRINTABLE_RADIUS is better than DELTA_PROBABLE_RADIUS for setting the probe limits.   This is because the automatic probe code checks all locations for being reachable by the probe prior to doing the probe.

Based on #8426

2.0.x E0 auto fan fixes for LP1768

[2.0] Fix Filament Width Sensor LCD display

Fixes #7978

[2.0] Add OV() macro for use in thermistor tables

[2.0.x] Fix Software Fan PWM

[2.0] Fix 'M32 P' subroutines

[2.0] Fix parser value handling

[2.0] Add M114_DETAIL to Configuration_adv.h

[2.0] Fix up REPRAPWORLD_KEYPAD defines

[2.0] Move test extrusion options under G26

[2.0] Support for Extrudrboard in Printrboard Rev.F

[2.0] Update Travis CI, fix compiler warnings

As modified in #8395

[2.0] Improve and clarify M428 code