include LPC1768 syntax for M42

couple more pin_t changes

consistency

change M42 to R, P format

Revert "change M42 to R, P format"

This reverts commit 01f12f579e.

If using babystep to adjust the Z probe offset, the axis will move and the mesh will be updated at the same time, causing a doubling of the Z offset over the rest of the print.

To correct for this, the current Z position would need to be modified in the opposite direction, canceling out the additional Z offset added to the mesh. This would be confusing to users, and moreover it would not be accurate without also taking the current Z fade level and current Z height into account.

It might make sense to change the mesh in the case where no babystepping is taking place, but this could be considered an undesirable side-effect of changing the `zprobe_zoffset`.

One way to remedy this would be to return to storing the mesh with `zprobe_zoffset` included, then subtracting `zprobe_zoffset` from the returned Z value. Thus, a babystep moving the Z axis up 1mm would subtract 1 from `zprobe_zoffset` while adding 1 to all mesh Z values.

Without including the `zprobe_zoffset` in the `z_values` there is no safe way to alter the mesh in conjunction with babystepping, although it's fine without it.

* fix M48 for delta printers

fix M48 for delta printers. home printer if not already homed.

* remove ENABLED(DELTA)

remove ENABLED(DELTA) as it is not needed.

* Update M48.cpp

* abl needs queue.h

without queue.h abl will not compile since there is a script that runs at the end of it and we need to queue it up.

* Update Conditionals_post.h

* Add a cast to round() to convert to a unsigned int

Add's a cast to round() so that it will compile properly. round() returns a float which must be cast to a integer for the following % operation. Use a unsigned int as a negative index to an array is wrong. Should never be more than 255 points allowing us to use a 8 bit cast.

* Update G33.cpp

* [2.0.x] G33 magic numbers

* oops

* Comments

* oops

* warning

* better comment section

* remarks

* extra grids

Addressing #6655

* [2.0.x] Fix NO_MOTION_BEFORE_HOMING unwanted behaviour

NO_MOTION_BEFORE_HOMING should prevent XYZ movements only when homing is not done.
E axes should be allowed

* Update G0_G1.cpp

* Update G0_G1.cpp

* (2.0.x) serious bug G33

* Revert config changes

This reverts commit 74b5a98223.

* Merging early because of build failures.  See #8105

* Make LPC1768 pinmapping not specific to Re-ARM

* Add HAL_PIN_TYPE and LPC1768 pin features

* M43 Updates

* Move pin map into pinsDebug_LPC1768.h

* Incorporate comments and M226

* Fix persistent store compilation issues

* Update pin features

* Update MKS SBASE pins

* Use native LPC1768 pin numbers in M42, M43, and M226

* Enable hardware serial ports on LPC1768

* Fix compilation errors with other HALs

* FIx order of includes in LPC1768 HAL main.cpp

* Add support for RX_BUFFER_SIZE and TX_BUFFER_SIZE options in Configuration_adv.h

set_destination_to_current() changed to set_destination_from_current()

set_current_to_destination() changed to set_current_from_destination()