Marlin v1 configurable serial port

This change makes the choice of serial port configurable so that
wireless capability can be easily added by connecting Bluetooth modules
(such as BlueSmirf or JY-MCU) to the expansion port pins.

Fix num of digits on LCD for E and Z axis.

Fixed wrong code (will not even compile when EXTRUDERS>2)

This reverts commit cb02c2f9d8.

The number of steps per mm often contains 4 digits before the decimal point and does not require precision greater than 0.1

fix LCD temp bed artifacts on power up ' B022/0.) -> B022/000 '

Create an explicit rule for building applet/Marlin.cpp.

Italian language support

It would seem that the pattern matches do not work when the source
file is created when make is running. The result of this is that it is
necessary to run "make" twice to build the firmware.

This adds an explicit rule without a pattern match for building
applet/Marlin.cpp it corrects the make behaviour at the cost of adding
a little redundancy in the Makefile.

Added Russian translation

Marlin v1

Remove unwanted artifacts in merge of bed-pid tree

PID for heated bed

Spanish language updated

Dialogs from M119 translated, and "Set Preheat" dialogs adapted to the
screen size.

Changes to M119 response for easier visual comparison

Changed to report on individual lines with "TRIGGERED" or "open" instead of "H" or "L" on one line as H&L could be confused with logic levels High and Low which may be wrong if using inverted logic.  Added strings to language.h.

Fixed typo "deu" in English language that was fixed in #134 but got added back in via 9f7f7354f5

Limit Switch locations based on MIN/MAX limits and homing direction

fixes #246
Added statements to set the limit switch positions to the maximum travel if homing in the positive direction as well as bed center at (0,0) if defined.
Relocated code based on feedback.

Added statements to set the limit switch positions to the maximum travel if homing in the positive direction as well as bed center at (0,0) if defined.

Slight modification for byte savings

Binary representation for characters in ultraldc.pde

Fix M81 not working reliably on Gen7

Added function 'setTargetedHotend' that turns into a function an operation repeated 3 times through the M-codes processing.

This modification saves a few bytes that can be used to add support for new commands.

The joris' char drawins are expressed in binary so to show their content's in a more visual fashion.

This is not a code modification as much as a readibility modification.

Some discussion of the issue is here http://forums.reprap.org/read.php?181,118329,page=1