Update distribution date and readme

Follow-up the PR #4408 (Add support for reprapworld LCD), etc

Make Conditionals.h a catch-all for old configs

・Put #define REPRAPWORLD_GRAPHICAL_LCD into all the example
configuration files
・Adjust spacing

Followup to #4468

Fix for PR #4453 (Improved MANUAL_[XYZ]_HOME_POS)

Improvement to non-blocking speaker

Specify manual-movable E axes by extruder type

Makes safe_delay() to be fully compatible with delay()

double bump probing as a feature

Additional heater-state output changes

Account for DELTA in Planner::refresh_positioning

Why double touch probing is not a good thing.

It's widely believed we can get better __probing__ results when using a double touch when probing.

Let's compare to double touch __homing__.
Or better let's begin with single touch __homing__.
We home to find out out position, so our position is unknown.
To find the endstop we have to move into the direction of the endstop.
The maximum way we have to move is a bit longer than the axis length.
When we arrive at the endstop - when it triggers, the stepper pulses are stopped immediately.
It's a sudden stop. No smooth deacceleration is possible.
Depending on the speed and the moving mass we lose steps here.
Only if we approached slow enough (below jerk speed?) we will not lose steps.

Moving a complete axis length, that slow, takes for ever.
To speed up homing, we now make the first approach faster, get a guess about our position,
back up a bit and make a second slower approach to get a exact result without losing steps.

What we do in double touch probing is the same. But the difference here is:
a. we already know where we are
b. if the first approach is to fast we will lose steps here to.
But this time there is no second approach to set the position to 0. We are measuring only.
The lost steps are permanent until we home the next time.

So if you experienced permanently rising values in M48 you now know why. (Too fast, suddenly stopped, first approach)

What can we do to improve probing?
We can use the information about our current position.
We can make a really fast, but deaccelerated, move to a place we know it is a bit before the trigger point.
And then move the rest of the way really slow.

Fixes a compilation error introduced by #4448

Improved MANUAL_[XYZ]_HOME_POS

No need for `MANUAL_HOME_POSITIONS`. Just set each one as-needed to
override the automatic behavior.

Fix output of heater states

Switch Sd2CardLib to fastio

A little cleanup at speaker.h

Prevent compiling with old Arduino sooner

Fix DELTA speed calculation

Fix for R.D.F.G.S.C. with MEGATRONICS 3 board

The support for reprapworld LCD boke the code for the REPRAP_DISCOUNT_FULL_GRAPHIC_SMART_CONTROLLER. See Full Grapics Display does not work any more after #4408  #4439

DELTA should ignore Z_SAFE_HOMING

Allow Z_SAFE_HOMING without a probe