Fix #9732

From @rmoravcik at #9760

- This status screen uses the ST7920 character generator to greatly
  reduce SPI traffic and MCU load when updating the status screen.

- Has been tested with the RepRapDiscount Full Graphics Smart Controller
  but should work with any LCD that uses an ST7920 or fully compatible
  controller.

- This makes it look less like a dash (idea stolen from cjsoong).

- This will slightly reduce the SPI requirements for
  updating the progress bar.

- Also deleted old implementation files which had been renamed.

Fix #9685

- Moved bed icon down when the machine is configured with two nozzles.

Fix #9711
Replacing #9731

Reference #5367

- The status screen uses the ST7920 character generator to greatly
  reduce SPI traffic and MCU load when updating the status screen.

- Has been tested with the RepRapDiscount Full Graphics Smart Controller
  but should work with any LCD that uses an ST7920 or fully compatible
  controller.

* VIKI2 & RE_ARM changes

1. Remove `DISABLED(SDSUPPORT)` from ST7565 in `ultralcd_impl_DOGM.h`. These LCDs share pins with the SD card and can run at the SD card rates.

2. Add SDSS definition to `pins_RAMPS_RE_ARM.h`.  Apparently the SDSS definition in `pins.h` is being processed before the one in `spi_pins.h` which resulted in not being able to read the SD card.

Fix #9530
Fix #9524

- avr-gcc is more strict than the Arduino IDE, it seems.

- The status screen uses the ST7920 character generator to greatly
  reduce SPI traffic and MCU load when updating the status screen.

- Has been tested with the RepRapDiscount Full Graphics Smart Controller
  but should work with any LCD that uses an ST7920 or fully compatible
  controller.

Based on #9610

FILAMENT_LCD_DISPLAY can work with SDSUPPORT

Based on #9590 by @studiodyne

From #9508 by @tnw513

From #9514 by @1138-4EB

Add compatibility with the original screen bord from Ultimaker 2 printer (UltiController v2.1 with the PG-2864ALBP I2C display)