- Remove `print_job_timer.stop()` from `disable_all_heaters`
- Call `print_job_timer.stop()` for relevant `disable_all_heaters()`.
- Split up `kill()` for watchdog interrupt safety

- Fix an error in the return value of `sd_mmc_spi_read_capacity` which was causing the host OS to read beyond the last sector in the card.
- Clean up the USB flashdrive code and add better debugging.

* Add traceback after watchdog timeout

Add the cpability to perform a traceback following a watchdog timeout.

* Enhanced hardware SPI

Allow use of either SSP0 or SSP1.
Ensure that no data is left in I/O buffers after calls to enable sharing of SSP hardware.

* Make flash emulation of eeprom the default

Make use of flash for eeprom storage the default. This means that usage of eeprom will not cause USB drive mount/unmount operations.

* Allow sharing of SD card

SD card I/O operations from the USB stack take place in idle loop, rather than at interrupt time. Allowing sharing of the SPI bus.

New configuration options to allow usage of the SD card to be specified.

* Fix problem with hardware SPI pins

Framework and build platform now located at https://github.com/p3p/pio-framework-arduino-lpc176x and https://github.com/p3p/pio-nxplpc-arduino-lpc176x respectively

fix mkssbase leds

move hardware serial

remove hardware/software serial

Hardware Serial extraction

HardwareSerial ISRs

fix disabled serial2 causing Serial object to link

move usb devices out to framework

separate out adc/pwm peripheral function from hal.cpp

fix includes

remove unused pwm init

move adc

HAL header update

templated filtered adc

LPC1769 platform

* Allow override of soft SPI pins in `pins_*.h`
* Add default case to avoid compiler warning.
* Additional pin definitions for Archim 2.
* Einsy Retro has same timings as Einsy Rambo.

With default config and `EEPROM_SETTINGS`, saves over 200 bytes of PROGMEM.

Prescalers aren't calculated for the given target frequency.
Stepper timer should run at 2 Mhz and temperature timer at 72 Khz.

STM32 can reuse JTAG and SWD pins separately. Add `DISABLE_DEBUG` option to disable both interfaces and retain `DISABLE_JTAG` to disable JTAG only.

Some STM32-based boards may use multiplexed JTAG pins as IO. Up to now the `DISABLE_JTAG` option (defined in pins files) was only supported for AT90-based boards. This commit generalizes the code and adds support for boards based on STM32F1 and STM32F4.

Implement servo support for STM32F1. Original code was incomplete and depended on Servo library from stm32duino which conflicts with `module/servo.h`.

The `binary.h` file required by `lcd/dogm/dogm_bitmaps.h` is not present in stm32duino environment. Binary macros are defined in `bit_constants.h` in stm32duino framework.